How To Replace Ac Compressor Bearing. Maintain the compressor in that position by placing a block of wood between the front of the compressor and the top of the engine. Can i replace the compressor clutch without removing the compressor from.
The ac compressor replacement cost can go between $750 and $1,200. How to replace ac compressor bearing. Maintain the compressor in that position by placing a block of wood between the front of the compressor and the top of the engine.
I Replaced The Bearing In Mine On The Vehicle Which Was Relatively Easy.
You can opt to buy a remanufactured ac compressor or buy a used one from a junkyard to save some money, but it is not recommended. The objective is to replace the ac clutch on the car. Joined may 18, 2012 · 76 posts.
Can I Replace The Compressor Clutch Without Removing The Compressor From.
Clutch kit is sunair part ca 401d if it was me and the bearing was shot i would do this. (napa) and the ac compressor also will be in the ballpark of $262.99. Bearing replacement is only effective if the system is otherwise in good working condition (compressor has not seized, system has not leaked excessive oil, etc).
The Ac Compressor Replacement Cost Can Go Between $750 And $1,200.
I listened to the noise with a mechanics stethoscope and determined that the noise was either coming from the air conditioning compressor pulley bearing or the belt tensioner. It may be tight and you may need a puller. Replacing the noisy bearing without finding the root of the problem and fixing it permanently will only lead to premature damage of a new component and a waste of time and money.
The A/C Compressor Pulley Wobbled And Made Noise When I Spun It.
Sometimes replacing the entire compressor with a remanufactured one can be cheaper than replacing an individual clutch or bearings. It saves you having to press out/in the bearing and only adds about 30 minutes to the job. Steps to remove the pulley:
Once Again I'd Only Do This On Low Mileage Or Vehicles That Have No Issues With Warm Air And Only Have A Noisey Pulley.
99 tj (4.0) ac compressor pulley bearing replacement. Remove the belt remove the bolt in the center of the compressor clutch pull the outer clutch disc off. * see below remove the circlip pull the pulley off remove and replace the bearing reassemble