How To Light A Pilot Light On A Gas Water Heater. While still holding the gas down, light that pilot. Once ignited, release and turn the gas knob to the “on” position and listen for the main burner to turn on.
How to Reignite Your Water Heater's Pilot Light Mr. Rooter from www.mrrooter.ca
Before you start it is easy to check if your pilot light has gone out and to relight it, but as with all home repair jobs, when attempting to relight your pilot light take extreme caution. Use either a lighter, match or candle to provide the flame required to relight the pilot light. A pilot light is always burning while using a small amount of gas;
Either A Water Heater Is Running Or Not.
This will start the flow of gas so you can light the flame. While still holding down the knob or button, use an extended lighter to reach into the access and ignite the pilot. Lift off or unsnap any access cover that blocks access to the burner.
Locate The Pilot Burner Beneath The Gas Water Heater.most Modern Water Heaters No Longer Use Standing Pilots.occasionally, No Light At All Is A Problem — It Means The Pilot Light Is Out.
Dial or rotate the gas control knob to the pilot position. While holding the gas switch down or the button, light the pilot. Place this fire source under the orifice of the pilot supply line to ignite the.
Illuminate The Pilot Burner With The Flashlight.
Go back to the gas valve and turn the knob to “pilot.” by pushing the knob down, you will start the flow of gas to the pilot. The pilot light is a small flame that lights the main burner whenever the tank needs heating and should be on at all times. Depending on the model, your water heater may have an igniting button, or you might need to light it manually with a long lighter.
Turn The Gas Knob To “Pilot,” Press And Hold It Down.
Right after a second, press the ignition button till the status light begins to blink every few seconds. On some water heaters, the lowest setting is labeled for pilot lighting. Push the on/off/pilot dial downward with one hand while lighting the barbecue lighter with the other.
Some Older Water Heaters Require You To Apply A.
Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. Use either a lighter, match or candle to provide the flame required to relight the pilot light. To light an electric water heater, start by setting the temperature control to the lowest temperature and turning the gas regulator valve to the “off” position.
