How To Install A Water Softener Drain Line

How To Install A Water Softener Drain Line. Where to install a water softener One of the requirements of the water softener is a drain for a valve overflow and a salt storage tank overflow.

Residential Water Softener Drain installation tips Greg
Residential Water Softener Drain installation tips Greg from gregknowswater.com

One of the most important components of a proper softener installation is provision for safe drainage by avoiding a possible “cross connection”. Less than 30 feet in length and no more than 8 feet above the floor level. In addition, the end of the drain line should be secured so that there is never any chance that it can become immersed in waste fluids or it can spray water into the surrounding area.

The First One Will Be Installed To The Control Valve So That The Backwash Water Is Disposed Of During The Regeneration Cycle.

Open the tap at the lowest level and let the water run out. The first line of the drain is a valve made for disposing of the water during the regeneration process. How to install a water softener drain line.

If You Have To Travel A Long Distance Raise The Line And Then Angle It Down Toward The Drain If Possible Still Increasing The Diameter.

How to install a water softener drain line when you are installing a drain line for a water softener, you will need to have two lines. This will dispose of the backwash water during the regeneration cycle. The drain should not be more than 30 feet away from the softener and the drain line should not be elevated more than 8 feet above the floor.

After Installing The First Line Of Your Water Softener Drain, You Need To Connect It With The Other Tube.

I'm looking to install a water softener in my basement and i'm trying to figure out where to plumb a drain for it. The result will be hardness leakage and/or salty taste in the water. One of the most important components of a proper softener installation is provision for safe drainage by avoiding a possible “cross connection”.

Make A 1/2 Line Into A 5/8 Into A 3/4 And So On.

Next, connect your drain hose. Both of these overflows are 3/8 clear flexible hose. The hose outputs are located about 30 and 40 above floor level, respectively.

Install The Second Drain Line To The Brine Tank, And Lead This To The Same Drain That You’re Using For The Water Softener.

How to install water softener drain pipe line? The unit comes with a 10 foot power cord. Less than 30 feet in length and no more than 8 feet above the floor level.

Leave a Reply

Your email address will not be published. Required fields are marked *.

*
*
You may use these <abbr title="HyperText Markup Language">HTML</abbr> tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>