How To Clean Water Heater Anode Rod. Turn on the heater open hot water faucets to get mixture into those lines wait an hour remove both the safety valve and drain (carefully!) flush tank from above (through safety valve). Anode rods work by attracting corrosive particles found inside your water heater tank to protect the tank liner and reduce the risk of explosion.
Reinstall the anode rod and switch the cold water supply back on, this will cause the tank to refill. Remove the insulation and unthread the anode rod using the socket wrench; When you remove the anode rod, you will notice a hole in its place.
Remove The Insulation And Unthread The Anode Rod Using The Socket Wrench;
Here is where you need to place the funnel. It’s time to remove the anode rod from the water tank once you’ve found it. You can see one problem right away:
The Life Of A Water Heater Can Be Halved If The Anode Rod Is Removed.
You might also consider flushing your water heater out at least once. Turn off the power or gas. Some anode rods are linked with the hot water outlet above the tank.
Don't Drain Any More Than This Because The Weight Of The Water Will Help Stabilize The Tank While You Unscrew The Anode Rod.
If it's not clearly visible down to the tank shell, take a. The rest of the water heater probably looks like the anode. Anode rods are installed in water heaters to attract corrosive ions away from the metal tank.
Of Course, There Are A Few Minor But Important Details In Between.
Reinstall the anode rod and switch the cold water supply back on, this will cause the tank to refill. There, you will find a diagram showing where the anode rod is. Loosen the screws with a wrench.
How To Clean Water Heater Anode Rod.
Pry the plastic cap covering the anode rod off of the top of the water heater.remove the foam insulation then unthread the anode rod and pull it up and out from the tank. Generally, you can remove a stuck anode rod from a water heater by using a cheater pipe to increase leverage, and by securing the tank from spinning as you pull on the ratchet. But, as you can see, this is a project any homeowner can take on with relative ease and little plumbing knowledge.