How To Check Transmission Fluid Level Ram 1500

How To Check Transmission Fluid Level Ram 1500. Now, for checking or filling, open the fill plug. You cannot use a socket as there's no clearance.

How To Check Transmission Fluid Level Ram 1500
How To Check Transmission Fluid Level Ram 1500 from evottaparadise.com

Let engine warm up and continue to run throughout operation unless vehicle's owner's manual says otherwise. In the video, 1a auto shows how to check and top off the engine oil. Tranny fluid is supposed to be checked at operating temperature.

Bet It’s Less Than 1/2 What A Ram Dealership Would Charge You.

Gentlemen, you have to check it with the engine running. If checking, a teeny bit should flow out. Park vehicle on level surface, engage parking brake and start engine.

Never Touch The Fill Plug Cold.

The fluids for the differential depend upon the type of differential. You cannot use a socket as there's no clearance. Remove the transmission dipstick and wipe clean.

Check It When The Engine Is Off And You Will See That It's Overfull.

There is a risk of injury from contusions and burns if you insert your hands into the engine when it is running. While stopped, put it in drive for two seconds, then reverse for two seconds (doubt if the timing is all that critical). You cannot use a socket as there's no clearance.

Pull The Dipstick Out Of The Tube Again And Read The Level By Looking For The Fluid On The Dipstick.

Find the transmission fluid dipstick. Tranny fluid is supposed to be checked at operating temperature. Because the pump in your tranny has to be pumping the torque converter full of oil to get an accurate reading on the dipstick.

Never, The Proper Fluid Level Is Inches Above That Fill Plug Cold.

You should use a starscan tool, but only the dealers have those pretty much. Secure vehicle to prevent it from moving. If not done correctly, transmission life will be shortened.

Leave a Reply

Your email address will not be published. Required fields are marked *.

*
*
You may use these <abbr title="HyperText Markup Language">HTML</abbr> tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>